Embossed HTV Instructions for Heat Press Application

• Create design and place your setting to mirror in your design space.
  • Tip: By mirroring your design you are flipping the placement so when you place the design down it is right side up.
• Place color shiny side down on your mat. Dull side (no color) is facing up during cutting.
• Cut design and weed vinyl.
• Place item on the heat press and put your vinyl design in the area you want to press.
• Place a cover sheet (Teflon paper or Parchment paper) over your design and press with medium pressure at 300°F – 315°F for 15 seconds.
• Open press, allow design to cool and cold peel application sheet in 1 pull for best results.
• Remove product from press.

Embossed HTV Instruction for Hand Iron Application

• Create design and place your setting to mirror in your design space.
  • Tip: By mirroring your design you are flipping the placement so when you place the design down it is right side up.
• Place color shiny side down on your mat. Dull side (no color) is facing up during cutting.
• Cut design and weed vinyl.
• Set iron dial between Cotton and Linen pending the item you are pressing.
• Place on flat hard surface (Iron board is not recommended).
• To achieve best application press, don’t use the iron steam function.
• Place a cover sheet (Teflon paper or Parchment paper) over your design and press iron with firm pressure straight down for 30 to 60 seconds (pending the design).
  • Tip:  Don’t move iron slide to slide.
• Allow design to cool for a few seconds and cold peel application sheet in 1 pull for best results.
  • Tip:  If design lifts up during cold peel process, re-press design area with a cover sheet for 10 seconds.

Material Recommendations for HTV Vinyl

• All products should be polyester or cotton. Nylon materials will not work.
• 100% Polyester
• 100% Cotton
• 50% cotton / 50% polyester

Care Instructions

• For best care we suggest waiting 24 to 48 hours before washing your garment.
• Suggest to turn item inside out and washing in cold water.
• Suggest to dry on low setting or hang dry item for best care.
• Suggest to stay away from using chlorine bleach.

HTS Recommendation for Project Tools

• HTS Cooling Block is a great tool to make sure your press is fully cooled off and applied.
• HTS Mini Tweedy or Tweedy Lites are a great help with weeding fine lines.